MPC with Focusrite Clarett Output Routing

Hello!

I’m having issues routing audio out of my Clarett which is setup as the audio interface in standalone mode.

Basically on the Clarett there are 4 audio outputs. Two of these goto my speakers, the other two I send to my stereo tube compressor, then route back into a stereo audio track in the MPC.

In the MPC anything I want to go through the compressor I send t

My post got cut off, here is the full post:

Hello!

I’m having issues routing audio out of my Clarett which is setup as the audio interface in standalone mode.

Basically on the Clarett there are 4 audio outputs. Two of these goto my speakers, the other two I send to my stereo tube compressor, then route back into a stereo audio track in the MPC.

In the MPC anything I want to go through the compressor I send to outputs 3/4. However it seems to ignore this and just send everything though as if all channels are set to 1/2. I can have literally nothing set to 3/4 and it still gets all the channels send to it, like internally the interface is replicating 1/2 on 3/4, ignoring the routing in the MPC.

Does anyone have any idea what the issue might be?

Thank you!

Justin

I think for the Clarett you have to create a custom mix using Focusrite Control. The default mix is all inputs routed to all outputs, probably. I don't have one of these interfaces but I went through the same thing for my UAD interface.