By i7718
Mon Mar 25, 2024 9:37 pm
Firmware 2.10.1 fwiw.
I'm using a MIDI clocked looper slaved to the MPC to record my guitar. I record a perfect loop on the looper, then hit record on the Tascam 12 and record the audio to SD and move it to my laptop. I play the file on the laptop and it sounds just like it did on the looper.
So I take that file and put it on the SD card that belongs to the MPC. I open a project and preview the sample and it sounds great again...exactly as it did on the looper.
So I load it into the program and give it a listen. This is where the sample "speeds up" and no longer sits in the BPM it was recorded at...even if I start a brand new project. Not only that, but every sample also tails off and loses volume as if it's already had a fade out applied.
The audio file does NOT change UNTIL it's actually loaded into the project...behaves normally up until that point.
I've done all this before with great success, so I suspect user error...but I can't find any settings while menu diving that look applicable. Even when I open up the project where I've previously succeeded, the new sample I recorded today behaves the same as previously described.
Any ideas?
I'm using a MIDI clocked looper slaved to the MPC to record my guitar. I record a perfect loop on the looper, then hit record on the Tascam 12 and record the audio to SD and move it to my laptop. I play the file on the laptop and it sounds just like it did on the looper.
So I take that file and put it on the SD card that belongs to the MPC. I open a project and preview the sample and it sounds great again...exactly as it did on the looper.
So I load it into the program and give it a listen. This is where the sample "speeds up" and no longer sits in the BPM it was recorded at...even if I start a brand new project. Not only that, but every sample also tails off and loses volume as if it's already had a fade out applied.
The audio file does NOT change UNTIL it's actually loaded into the project...behaves normally up until that point.
I've done all this before with great success, so I suspect user error...but I can't find any settings while menu diving that look applicable. Even when I open up the project where I've previously succeeded, the new sample I recorded today behaves the same as previously described.
Any ideas?