Sending control change messages from MPC MIDI program ?

So, I have a midi instrument and it's CC#... Can use a MIDI program on the MPC to sequence those CC ? I would love to input them in the grid.

Neither the Manual, nor the Bible or forum messages seem to explain that - mentions are mostly about the MPC receiving CC. It is impossible, or am I missing something obvious ?

Yes, it's just basically automation. Read the section on automation in the manual, and then realize that you can add CC automation either by drawing it in the editor, or by recording it from your instrument, or by moving the various sliders in the midi program on the MPC while recording.

Thanks, I'll dig in that direction !

Success: as you mentioned, CC are just another automation item... Draw & go ! My mistake was imagining they were handled as notes.

Muhahahaha - this opens so many possibilities !