Unable to save projects to SD card.

When I go to BROWZER and select SAVE option and SAVE AS
I select SD Card from storage window left side.
I then select PROJECTS file from right side window,
Select SAVE from lower bottom right,
I get READ ONLY FILE SYSTEM
Unable to write selected location
I tried NEW FOLDER and received the same window.
Any ideas?
I’m at 3 gigs on internal and want to practice
MPC BIBLEs direction to save on SD card.
I have a few projects on the SD can’t remember what I did differently.
¯\_(ツ)_/¯
Thanks.

If you haven't somehow re-formatted the disk to a read-only format, then it could be that your card is corrupted/failing. Can you try with a different card?

SD card can have a physical read-only tab that can get accidentally switched.

dstengle wrote:SD card can have a physical read-only tab that can get accidentally switched.

If that's the cuase, I put tape on that side tab. Mine was loose & I keep running into this. Ghetto fix, but I haven't had that problem in years. Don't use cheap ass tape. Just because it's ghetto doesn't mean you can't have standards

2 SD Cards died on me with that message, try to make a backup and get a new one, fast

Bingo, everyone!
I thank you for the quick response!

GeorgeCornwell wrote:Bingo, everyone!
I thank you for the quick response!

What was the solution, as there were a few different suggestions?

I flipped the read only tab on the card which denoted read only.
When I flipped it back and noted the marked through pencil had disappeared I tried to save a project. It again denied with the read only message.
I’m thinking it’s been corrupted as I never reformatted it.
I’m thinking i need a new card?