MPC 2 projects to MPC 3.x

It’s been a long time since I last visited the forum. I’ve been having issues transferring MPC 2.x projects into MPC 3.x.

When I open the projects, roughly half of the samples, tracks, or sequences disappear. For example, I might have a 16‑bar track inside a sequence, but when I load it in MPC 3.x, it only shows 8 bars and the rest is gone.

I’m hesitant to open more projects if they risk being corrupted or losing data.

Has anyone here experienced this issue or found a solution?

And remember you are not going to corrupt anything, the conversion creates a new version of the project, save it with a different name. But also, just keep a separate back up of your MPC2 projects

Lampdog wrote:It’s still there, just gotta highlight the end bar and scroll to make it longer.
It’s a bug imo, your sequence isn’t lost.

Okay thx. I hope it Will work!

MPC-Tutor wrote:And remember you are not going to corrupt anything, the conversion creates a new version of the project, save it with a different name. But also, just keep a separate back up of your MPC2 projects

Yeah. I know that. I was just hoping that I could convert it directly to the new software

I found another solution that worked.
My sequences were repeating themselves halfway through.
If i turn loop off in Arrange mode and then turn it back on, it works correctly.

Hope this help someone else.

Thanks for the quick replies "Lampdog" and "Mpc-tutor".