By re_i
Wed May 05, 2021 9:51 pm
Hey peeps,
I have just recently bought an Akai Force and wanted to know if anybody else has noticed audio clicks when using the Hype plugin with some presets, specifically Pads.
I have noticed some clicks when recording a clip whilst in chords or progressions note mode.
This wouldn’t normally be an issue but since I produce ambient and soundscapes, it’s noticeable.
Could somebody dial up the “Seafarer” preset under pad warm and record a clip using chords or progression, or any 3 notes and above clip, dial the cutoff down to say around 2% and you should hear clicking but not always at the same point in the clip.
I’m not sure if I have a hardware issue (which I doubt) but I’m leaning towards software.
It also happens to other pad sounds when played as a chord. I did manage to reduce some of the clicking by altering the velocity and fade knob on the filter/amp page.
I’ll be curious to hear your thoughts on this.
I have just recently bought an Akai Force and wanted to know if anybody else has noticed audio clicks when using the Hype plugin with some presets, specifically Pads.
I have noticed some clicks when recording a clip whilst in chords or progressions note mode.
This wouldn’t normally be an issue but since I produce ambient and soundscapes, it’s noticeable.
Could somebody dial up the “Seafarer” preset under pad warm and record a clip using chords or progression, or any 3 notes and above clip, dial the cutoff down to say around 2% and you should hear clicking but not always at the same point in the clip.
I’m not sure if I have a hardware issue (which I doubt) but I’m leaning towards software.
It also happens to other pad sounds when played as a chord. I did manage to reduce some of the clicking by altering the velocity and fade knob on the filter/amp page.
I’ll be curious to hear your thoughts on this.