By HouseWithoutMouse
Fri Feb 10, 2023 10:24 pm
Minor annoyance for which I found a workaround. If I have a macro knob with multiple controlled parameters, and the FIRST (topmost) of the parameters is a TOGGLE, but others are non-toggles, and if it's set to Momentary / Go to previous, then when I save the project and load it back, the knob's position remembers either 0% or 100% for its "previous" value, regardless of the position it (the knob, not the value) was actually at when saving the project.
The workaround for this is to use a non-toggle as the FIRST parameter of each knob. Then it seems to remember the actual knob position when loading, not just either 0% or 100%.
I don't know, maybe this is explained somewhere in the manual, but to me it seems counter-intuitive that the knob doesn't remember its actual position and the remembered position is tied to the first parameter. Maybe a bug, maybe not. But I found a workaround.
I must say the macros are a terrific feature. I couldn't stop smiling last night when I set up some macros for controlling a techno set.
The workaround for this is to use a non-toggle as the FIRST parameter of each knob. Then it seems to remember the actual knob position when loading, not just either 0% or 100%.
I don't know, maybe this is explained somewhere in the manual, but to me it seems counter-intuitive that the knob doesn't remember its actual position and the remembered position is tied to the first parameter. Maybe a bug, maybe not. But I found a workaround.
I must say the macros are a terrific feature. I couldn't stop smiling last night when I set up some macros for controlling a techno set.
