By B-Wise
Sat Mar 11, 2023 9:30 pm
Info on how he built the board the Force is on.
This from the YouTube comments:
I made my own mount. I went to HomeDepot, bought a 2’x4’ piece of 1/4” plywood and had them cut it to size for me. (The Force is 14wx15L, I had my cut 14x17l so I could have a little lip at the back) Then 4 ‘L’ brackets that I screwed in by hand (2 at bottoms, 1 each side near top), 4 felt pieces (for chair bottoms) so it doesn’t scratch the Force.
Put the VESA plate centered on the plywood, traced and drilled the 4 holes, bought 4x screws/washers/bolts.
So only tools I needed was a drill, drill bit, screw driver, small wrench.
Used black duct tape around edges so I wouldn’t have to paint it.
Spaces the two side brackets, with felt circles, so that it presses and holds the Force in tight even at steep angle, but easily removable. It just squeezes in and out between the felt pieces.
I have pics of the back side of the plywood at the Elektronauts forum (Digitakt setup page) or I can help you out if you’re interested in doing similar.
I took me about 45 minutes after coming home from the hardware store to drill/screw it together then I was up and running!