Discuss the various methods you use in music production, from compressor settings to equipment type.
User avatar
By Skiggy Tue Dec 07, 2004 11:39 am
Do any of u guys know how to make your programmed tambourines sound live, example would be Timbo, Cee-lo's "I'll Be Around", I've tried messing with velocity but they still sound machine like, any tips would be appreciated
User avatar

By DjChronoBeats Tue Dec 07, 2004 12:17 pm
don't quantize and use different samples, like don't use multiple instances of the same tambourine sample, load a diff. tambourine into each pad.
User avatar

By BRAVO Tue Dec 07, 2004 1:23 pm
The tambourine sample needs to a good one to start with...Velocity programming will help with the human feel factor your after. Also make variations of the sample....Mess with the decay...Tune/pitch it up & down by 1's and use them accordingly.

The drum pattern/ groove will also need to work for what your trying to achieve. To test your programming skills, copy the beat and see how close u can get it. Messing with the swing will also help u on this.

See how you go

B
User avatar

By Smoove03 Tue Dec 07, 2004 2:44 pm
i love tambs and i work with em all the time.

when im doing a tamb roll i take OFF Full Velocity and take OFF Timing.

I dont usually use more the one pad or sample, though it might be good to use 2 different tambs (one light and one heavy)

but, i just bang em out at a constant rate. with timing off it will sound how you bang it out.

thats how i do it and i've made some really nice tambourine rolls.

good luck

By arctec Tue Dec 07, 2004 3:41 pm
do all the above and then mic it up.
User avatar

By dubmunkey Tue Dec 07, 2004 4:06 pm
set the two samples to cut each other off but fake a very small decay by fudge looping- this means the sample will be cut but not so abruptly it sounds unnatural..

greg
User avatar

By Lampdog Tue Dec 07, 2004 4:27 pm
I actually use all the techniques that Chrono, Bravo and Smoove explained depending on how much work I feel like doing that day. I ALWAYS do more than just 1 tamb sample though.
User avatar

By Skiggy Fri Dec 10, 2004 6:42 am
two different tambs why the hell did I never think of that,good lookin everybody
User avatar

By Smoove03 Fri Dec 10, 2004 2:44 pm
but if you turn off full velocity, then you may not need two tambs. i do it all the time. for the light sounding tamb, just dont hit the pad hard. and for the hard one hit it a bit harder!
User avatar

By Lampdog Fri Dec 10, 2004 4:34 pm
I can also use 3 different samples and
use Velocity Switching between them...
See pg 119 xl manual.

I use this method quite alot...
User avatar

By Smoove03 Fri Dec 10, 2004 4:38 pm
true!

something i can try later. thanks