mpc2000xl tact switches

can someone tell me more specific technical specs about the small tact switches used in an mpc2000xl (or a shop in europe where i can cop them)? i know they're available at mpcstuff, but 8 usd each + 20 usd shipping costs to europe would be rather expensive since i need to replace quite a few of them.

d-oh wrote:can someone tell me more specific technical specs about the small tact switches used in an mpc2000xl (or a shop in europe where i can cop them)? i know they're available at mpcstuff, but 8 usd each + 20 usd shipping costs to europe would be rather expensive since i need to replace quite a few of them.

Where are you from?

You can get the tact switches at Conrad electronic for a few cent.

http://www.conrad.de/ce/de/content/cms_ ... ernational

I bought some of them too but cant remeber which one it was.

wait...



I think it was the fsm2jh

PRT Number at conrad is 701749 - 89


peace

i'm from austria, so conrad would be great for my purpose. the PRT for 'fsm2jh' is '701749 - 62' on the german and austrian websites instead of the '701749 - 89' that you mentioned (found this PRT on www.conrad-uk.com), though. but it seems to be the same switch as far as i can tell. is the switching voltage (24 V/DC) suitable?

thx alot!

maybe you could grab the service manual... there is a thread around here with all the models posted except for the 5000.

d-oh wrote:i'm from austria, so conrad would be great for my purpose. the PRT for 'fsm2jh' is '701749 - 62' on the german and austrian websites instead of the '701749 - 89' that you mentioned (found this PRT on http://www.conrad-uk.com), though. but it seems to be the same switch as far as i can tell. is the switching voltage (24 V/DC) suitable?

thx alot!

Huch da hab ich wohl die Nummer von der falschen Seite genommen Aber du hast sie ja gefunden. Das sind die Taster die ich für mein 2000er benutzt hab und die funktionieren super. 24V meint ja nur dass man sie mit bis zu 24V belasten kann und so eine hohe Spannung ist auf der Platine mit den Knöpfen nicht vorhanden.
Eine Anmerkung noch: Die Taster sind nur für die "kleinen Knöpfe" (Zahlen, F1-F6 und so) für die Transportknöpfe brauchst du andere Taster (die hab ich bei Conrad allerdings noch nicht gesehen bzw gesucht weil meine noch in Ordnung sind)

peace

danke für den hinweis, glücklicherweise sind die größeren taktschalter bei meiner mpc noch in ordnung

peace