By asrvegas73
Thu Sep 27, 2012 4:20 pm
HI,
acquired a 3000 and have read posts about the velocity on the pads etc.
Mine needs to be hit hard to reach full velocity. I read here that u can adjust vol velocity but all that does is have less effect on velocity even though drum is now louder.
My pads are responsive, they just need to be hit hard to achieve full levels.
Cleaning the pads sheet-mine seemed spotless. My question is should I be cleaning the underside of the sensor sheet (the sticky side) Ive only cleaned the top-it didnt seem right to rip out the glue side and clean that. Ive also applied bits of tape to the top of the sensors-no real change.
I also have an mpc 60 and its pads hit full volume easier
??
acquired a 3000 and have read posts about the velocity on the pads etc.
Mine needs to be hit hard to reach full velocity. I read here that u can adjust vol velocity but all that does is have less effect on velocity even though drum is now louder.
My pads are responsive, they just need to be hit hard to achieve full levels.
Cleaning the pads sheet-mine seemed spotless. My question is should I be cleaning the underside of the sensor sheet (the sticky side) Ive only cleaned the top-it didnt seem right to rip out the glue side and clean that. Ive also applied bits of tape to the top of the sensors-no real change.
I also have an mpc 60 and its pads hit full volume easier
??