By eskay
Sun Feb 24, 2013 7:52 pm
Hi,
I am sending individual pads / programs through to logic for a mix down. A few of the pads have fx assigned to them (eg a snare with a load of reverb on it).
When the pad is assigned to output 12 it sends the unaltered 'pure' sample without the fx on. Is there any way to send it with the fx or does it always bypass it?
The only way I can think of at the moment is assign it to ST and assign everything else to an unused channel, then record out of that.
Also, I am assuming the master eq and compressor are also bypassed when recording through individual outputs - is that right?
Any help massively appreciated thanks.
I am sending individual pads / programs through to logic for a mix down. A few of the pads have fx assigned to them (eg a snare with a load of reverb on it).
When the pad is assigned to output 12 it sends the unaltered 'pure' sample without the fx on. Is there any way to send it with the fx or does it always bypass it?
The only way I can think of at the moment is assign it to ST and assign everything else to an unused channel, then record out of that.
Also, I am assuming the master eq and compressor are also bypassed when recording through individual outputs - is that right?
Any help massively appreciated thanks.