Bug reports & end-user support for Akai's MPC Software 'controllers' including the new MPC Studio 2, the MPC Touch, MPC Renaissance & original MPC Studio and MPC StudioB lack.
By maccabud Mon Mar 04, 2013 10:01 pm
mine wont update? iv installed the v1.3.1 four times now and rebooted the computor every-time and it stays at v1.3 and doesnt update. anybody have any advice?
By elogical4now Mon Mar 04, 2013 10:27 pm
maccabud wrote:mine wont update? iv installed the v1.3.1 four times now and rebooted the computor every-time and it stays at v1.3 and doesnt update. anybody have any advice?



Per AKAI instructions, Make sure MPC software is closed and MPC hardware in on.

I've updated successfully every time using the method above.
By Record Hog Mon Mar 04, 2013 10:34 pm
If the software is closed, where do you click for the software update, the web?
By maccabud Mon Mar 04, 2013 11:06 pm
i close everything software anything else that isrunning. then run the update on the drive,hardware etc and the software -it goes through the installation process and completes and reboots when i get it back up and runing again its just the same as before iv checked on what is meant to be updated and no joy.. the bpm problem etc.. all still exists
By mQueue Mon Mar 04, 2013 11:47 pm
one of these days they're going to be able to deploy an update that isn't the whole 70mb application! glad to see they're upping their maintenance game.
By IBE Tue Mar 05, 2013 12:38 am
InspectahEX wrote:does anyone know what the issue was with sample audition in browser that they fixed in 1.3.1?



It may be the issue with the sequencer stopping when previewing sounds. That's the issue I had in 1.2 which I think carried over to 1.3 but I haven't been able to get to mines to even try out 1.3, busy with work.
By sokool Tue Mar 05, 2013 12:47 am
When I went to install the MPC v1.3.1.app this window came up...

Update MPC v1.3.1.app is damaged and can't be opened. You should move it to the Trash.

I tried downloading it over & over again restarting my computer running OSX 10.8...........so it works fine for everyone else??
By Jake Tue Mar 05, 2013 2:25 am
sokool wrote:When I went to install the MPC v1.3.1.app this window came up...

Update MPC v1.3.1.app is damaged and can't be opened. You should move it to the Trash.


I got this same message with 10.8.2 Mountain Lion. I doesn't work for me either.
By Art James Tue Mar 05, 2013 3:17 am
Jake wrote:
sokool wrote:When I went to install the MPC v1.3.1.app this window came up...

Update MPC v1.3.1.app is damaged and can't be opened. You should move it to the Trash.


I got this same message with 10.8.2 Mountain Lion. I doesn't work for me either.



me too WTF is that about?
By Louie lou Tue Mar 05, 2013 4:00 am
InspectahEX wrote:does anyone know what the issue was with sample audition in browser that they fixed in 1.3.1?


I think it was that when you auditioned the sample during playback your playback would get interrupted. There were a few other things I noticed different with auditioning samples in 1.3 that seem to have disappeared in 1.3.1.
By bobbybland Tue Mar 05, 2013 4:26 am
Bug with volume shooting to 100 % still happening with Analog Factory when record mode is enabled.

This needs to be fixed.
User avatar
By QuickStrike Tue Mar 05, 2013 5:21 am
:( Found a major bug! After every two times I save it,it crashes the third time I save during the save process. :nod:
By munkondi Tue Mar 05, 2013 9:20 am
working fine here on Mountain Lion

it finally is beginning to feel like a reasonably robust and workable software platform that can be built on

Pete, thanks to you and the team for this quick update and for your great communication (Dan is full of hot air)