Step Sequence Mode is broken (solved)! Thanks!

What the hell is this?
I've been meaning to say something about this for a while.

Try the steps below to see how step sequence mode is broken...

Change T.C. to 1/32nds
Try to fill in every single note in 1 bar while you have it in step sequence mode and T.C. set to 1/32nds...
You can't... there is no way to access the 1st half of the bar while in 1/32nds.
When you change the "Edit Bar" section it only accesses the second half of the bar. There is no way to write in 1/32nd notes in the first half of the bar with step sequence mode

Does this stuff even get tried out? I mean how could they miss something like this (they couldn't, they know it's 'half' assed (pun intended))?

I think your press pad bank B to go to the rest of the bar, then pad bank A to go back to the first half of the bar

Exactly. You must use the Pad Bank Buttons to access all the steps.

I had no idea... Thanks guys, I thought this was a bit too ridiculous of an oversight.... phew

It sucks we don't have a decent manual for this thing

i thought the same thing, not sure if its in the manual or not

Airyck wrote:I had no idea... Thanks guys, I thought this was a bit too ridiculous of an oversight.... phew

It sucks we don't have a decent manual for this thing

While I agree that the initial manual isn't as thorough as the manual found in legacy MPCs....however, this specific function we are discussing is in the manual. Likewise, there are posts in this forum written everyday asking for help for functions that are in the manual.