How to install 8 outputs to mpc 2000 classic

Hi guys,
Does anyone know and can give some details (if you can provide me some photos would be great) on how to install the 8 outs to my 2000 classic?
I have searched the web but I didn't find any great help.
Thanks in advance.

I don't have any pictures & to be honest it's been a while since I did it, but I remember it was pretty simple. Do you have the manual? All I did was follow the instructions in the manual & I got it working with no issues.

I have download the manual and the manual for the software 1.72.
I will check it as soon as possible, thanks my friend.

Hey Retro Styles!
Like the guy above me said, it is quite simple :

- Remove the case
- Remove the board with the pads and buttons (don't forget to disconnect the cable that goes to the main board)
- Put the 8 outputs where it goes and connect it to the empty connector on the main board
- Put back the board with the pads and buttons (don't forget to reconnect the calbe that goes to the main board)
- Put back the case

And voilà It really is that simple!

Thanks guys you really helped me!

No problem man!
Let us know when you're done with the installation and if it went well

and make sure the ribbon is not backwards..

Oh, I will be very carefull
Thanks guys a lot.
After the 8 outs I will put and an analog mixer in the lab.
If you have any ideas please post 'em here
http://www.mpc-forums.com/viewtopic.php?f=11&t=176277
thanks in advance!