cleanin the mpc

yo my mpc was used so its got a few marks or some shit that i wanna clean off. I dont wanna do it with the cover on because i dont wanna get the mpc wet inside obviously . so ima take off the cover and clean it. what should i use to clean it so its nice and clean????

Also... can you buy like new covers for it or some shit? i want one of the blue covers that the new mpcs have. can you buy the from akai somehow? i dont wanna paint it my self because 1, im too lazy, 2, ill **** somethin up 3,i'lll lose the text for the buttons, 4,it wont look as good

peace

The manual sez:

• Avoid using aerosol insecticides, etc. near the MPC2000XL. They may damage the surface, and may ignite.
• Do not use denaturated alcohol, thinner or similar chemicals to clean the MPC2000XL. They will damage the finish.

I just use a little dish washing soap and water to clean the outside.

Scott wrote: i want one of the blue covers that the new mpcs have. can you buy the from akai somehow?

I would like to know that too

^Owni wrote:

Scott wrote: i want one of the blue covers that the new mpcs have. can you buy the from akai somehow?

I would like to know that too

why are you rolling eyes at me?

I use those antibacterial wipes!

Good Idea PENFOLD ......................


I MY Advice is this.....................


Somthing Light .........Non-Flamable is a must and then Dry it off.

I also Keep a Can of Air NEAR BY in my studio U never know dust
chips, rice or whatever and also I use the demagnetizin' variety to
fight static.

Office Supply store, they have the Can air by Endust and Endust Electronic spray that is 100% safe. I use it for all my PCs, TVs, DVD players, etc.
Just spray on rag and wipe!

DJ AMBUSH wrote:Office Supply store, they have the Can air by Endust and Endust Electronic spray that is 100% safe. I use it for all my PCs, TVs, DVD players, etc.
Just spray on rag and wipe!

YEP The Endust Joint is All Purpose Stuff !!!!!!

Everytime I come back from touring, the MPC is crazy dirty with sweat, dirt, and smoke residue.
I just take an old sock, spray 409 or Windex on the sock and wipe it down. If you spray onto the sock, you won't have to worry about getting the insides of the MPC wet.
The 409/Windex has never caused any damage to my MP.