By Dusty Snares
Sat Sep 01, 2018 7:53 am
how do you get rid of the humming that comes from the outputs of the 60
By djkaoz
Tue Nov 27, 2018 4:39 pm
Try to use DI Boxes or Groundloop Isolators... Works for me, but still want to know, why it is humming..
By Wal Martian
Tue Nov 27, 2018 5:19 pm
I think it's from the LCD power inverter. Disconnect the inverter and replace the screen with an new LED screen.
By djkaoz
Tue Nov 27, 2018 5:28 pm
My Inverter is gone.... LED Screen and still Humming....
By Wal Martian
Tue Nov 27, 2018 5:39 pm
There is a small gain switch on the rear panel, with Gain settings Hi, Med and Low. Each setting with make your signal louder, but it will also increase the noise floor. Hi will be loudest, try Med and Low. Check the power in your studio, use a Furman or Monster power conditioner. Make sure all your equipment goes to one power outlet/ground in the wall. If you plug in to a number of different outlets around the room you can create ground loops.
By Dj Khayos
Fri Dec 21, 2018 11:57 pm
Make sure that the screws that holds the floppy drive is tightened,
had this problem with my MPC3000 in the past.
If it doesn't get proper ground via chassi you will get hum in the outputs.
If you use an HXC floppy emulator check if you need to do the resistor mod.
http://torlus.com/floppy/forum/index.php
had this problem with my MPC3000 in the past.
If it doesn't get proper ground via chassi you will get hum in the outputs.
If you use an HXC floppy emulator check if you need to do the resistor mod.
http://torlus.com/floppy/forum/index.php