By Ayekai
Wed Feb 06, 2019 7:02 am
So just bought a Mpc 2000, I am currently refurbishing it and noticed that the ribbon cable connector where the pad sensor strip plugs into is lose on the board and is raised a tiny bit. The solder joints look fine however.
Not sure if this is normal as this is my first mpc. If this is normal i might just hot glue it for peace of mind as it feels pretty flimsy.
Not sure if this is normal as this is my first mpc. If this is normal i might just hot glue it for peace of mind as it feels pretty flimsy.