Lampdog wrote:Yep, one shot. No need to hold down anything or loop anything.
Just bang the pad when you need it to play again.
After that trim the end and/or slightly pitch/tune so when it retriggers in the sequence it plays smooth.
We went through this before when I helped you with that one loop but I think you had figure it out or something right before I got back to you or was it someone else who gave a clue how to fix it??
I think I remember..I had a loop that kept cutting out when converting to song and another one before that where I uploaded the file to google drive... They were both part of the same issue tho Idk Who detailed it out for me but essentially I was using The same parts for different programs on different tracks, which i guess in playback I didn't notice but during conversion It was audibly missing a part which I uploaded a video on since i was using the same part on different tracks but If I tried to change the part to the correct one , a different part of the song would sound off because the sounds I wanted together on one pad were separated into different programs,, Anyway, learning the outline of Tracks / Parts/ and Programs and especially keeping Separate parts for separate tracks and separate programs and how they fit was really the solution. That and taking a break from the forum and spending time reading the manual.
This was different because I used to get a whole loop on one pad and hold it down so i wouldnt run into the TC issue. However, because I decided to Sample from Vinyl and Trim to 16 regions and record a pattern that way, the TC issue would show up since I'm pressing multiple pads... I didn't think it was TC at first because I always used it when I had a whole loop on one pad so I figured that wasn't the issue but I just now learned it doesn't really apply to that because I'm only hitting one pad and letting it play, vs. Multiple pads and multiple data points being sent to the sequencer.. so when I played down my pads and noticed my pad data being recorded but not being played I knew something was off.. cause it was reading the data but not playing it. It was just Timing Correct
Anyways, Imma take that retrigger trip and the tune tip. I've just been re-recording or messing with the BPM to fit it into the sequence timing but I haven't messed with tuning / pitch minus the mixer and the Q-Link.