Auditioning Samples

Heres a new one, when I go to load sample and preview by pressing play the sample plays too fast as if it has been pitched up a lot. Is there a setting or something I have hit by accident. By the way the samples are saved at the correct pitch and play at the correct pitch but audition pitched up. Once they are loaded they play correctly. What the hell is going on? Any advice?

i was gunna say that they must be at the wrong sample rate or bit rate, but if they play ok when you load them... no clue... that's weird dude.

Its very weird and as yet nada explanation from anyone here. I think it must be a bug but has anyone had this? Even if you don't know the answer would make me fell better knowing that i wasn't alone..

HK wrote:Its very weird and as yet nada explanation from anyone here. I think it must be a bug but has anyone had this? Even if you don't know the answer would make me fell better knowing that i wasn't alone..

**** me.

i went to load a break i have previously recorded.

In reaper it plays fine, normal tempo.

In audition (mpc) it plays really fast, like its pitched up.

Then once i load it into a program it plays only slightly sped up, but not the same as original.

I have a feeling its something to do with the JJ i was using previously but havnt found a suitable answer either my man.

I think this happened.to me at least once, but not recently.

I would do the default reset and see if it goes away. Hold ERASE while you turn the unit on.