King_Vitamin,
It looks to me from your picture that you had to remove all the foam to get your MPC2500 in your case. If that's the case, is it a snug fit or is there extra room. If so, will the MPC2500 be moving around in the case when travelling?
Jeff
By mikepricew2k
Wed Jan 02, 2008 5:26 pm
By episode
Wed Jan 02, 2008 9:06 pm
King_Vitamin wrote:My bad, the one i have is actually the guardforce GDS-7236C. Guardforce makes the vanguard **** which is why i got confused.Do you place a foam between the top part of the case and the actual MPC when you're transporting it? You know, to protect the pads, knobs, and buttons if your case gets overturned.
They look identical except the guarforce is like 18" x 14" x 5" i think:
By King_Vitamin
Thu Jan 03, 2008 1:04 am
There's about an inch of space in the back. I filled it with the cubed foam that came with it so when you carry the case by the handle, it has some extra cushining. It has padding around every surface including the top and sides already glued in.
No i don't use an extra piece of foam between the pads and the lid because it already has about an inch of dense foam on the top and bottem, but you could if you wanted. I just make sure I don't lay it upsidedown.
No i don't use an extra piece of foam between the pads and the lid because it already has about an inch of dense foam on the top and bottem, but you could if you wanted. I just make sure I don't lay it upsidedown.
By mikepricew2k
Thu Jan 03, 2008 8:06 am
king_vitamin, thank you for your response. Is it a snug fit or is there a little bit of wiggle room?
By Archite©h
Thu Jan 10, 2008 9:53 am
Soundz like a nice case!
My question iz, can you only get da MPC in there?
Iz there room 4 cablez and a few cdz?
or will I av 2 carry dat shit around in a seperate bag!
My question iz, can you only get da MPC in there?
Iz there room 4 cablez and a few cdz?
or will I av 2 carry dat shit around in a seperate bag!
By Archite©h
Fri Jan 11, 2008 8:38 am
Cool man, bn checkin da forum @ work.
didnt realize there were picz coz they dont show here, didnt realize until i had signed in @ home!!
cheerz
didnt realize there were picz coz they dont show here, didnt realize until i had signed in @ home!!
cheerz
By eoneel
Mon Jan 14, 2008 4:50 am
I ended up trying out the guardforce GDS-7236C with my MPC2500. I ended up using it to keep a few pisols in instead because I did not like the fit. The dimensions were big enough for the MPC to fit, but one side of foam had to be taken out. With both foam pieces it was not able to close. I liked a case I saw here on these forums where the case was a little bigger which allowed the foam to be cut out in the middle for the MPC to nestle into. I will be doing something like that soon. Guardforce GDS-7236C was just a little to shallow and tight of fit to my liking.