Post your questions, opinions and reviews of the MPC1000. This forum is for discussion of the OFFICIAL Akai OS (2.1). If you wish to discuss the JJ OS, please use the dedicated JJ OS forum
By Arasia Fri Feb 20, 2009 3:54 pm
Hi, I am new in the forum, please I need to have help with my Akai MPC 1000, I can't recording samples, because the Time in the recording window, can't to change for have more timing to recording. I am inserting a new memory card of 2GB and formatting the card, but when I going to setting the process to recording the Time in the window, still set in 00:27 seconds. The user manual say is neccesary to change the Time before recording, but I am trying to do it, with any possitive results.
Help me please!
Thanks,
Antonio.
:(
By Arasia Fri Feb 20, 2009 6:33 pm
rinseout wrote:Try the factory reset, power up while holding down the erase button.


I have followed your recommendation and it even continues appearing:
"SAMPLE MEMORY"
"FREE MEMORY ( TIME ) = 0m27sec."
"16 MB INSTALLED"

It will be that I am making something erroneous?
User avatar
By bicedidit Fri Feb 20, 2009 6:48 pm
Arasia wrote:
rich_biatch wrote:did you add ram?


YES, I INSTALLING A MEMORY CARD WITH 2 GB, AND FORMATTING THAT CARD. BEFORE START TO RECORDING...


the 2gb card is not ram. u need to upgrade the ram memory
User avatar
By rinseout Sat Feb 21, 2009 12:26 pm
Arasia wrote:Thanks, I'm reading the user manual, and I Ill going to buy the Ram memory EXM128, its cost $ 159.99

Once again thank you for the data! :)



You can get that much cheaper, read the sticky.

Deactivate autoload, though. Even with 16mb you should have more time for recording.