Technical questions for the MPC2000xl and the MPC2000
By JaccCetch Thu Sep 13, 2018 6:36 pm
I know this subject gets older and older but...I like MPCStuff's actual fatpads but without the corx there is just too much distances between the pad and the sensor! BUT with their corx applied (a little too thick in my opinion PAUSE), they are too CLOSE to the sensor causing double triggers. Does anyone know of an alternative to MPCStuff's corx??? Something not quite so thick (PAUSE AGAIN!) ? Thanks in advance
User avatar
By tapedeck Thu Sep 13, 2018 8:03 pm
i dont know of an alternative, but i would say a lot of that double triggering comes down to technique. you can keep playing / practicing and get better at it.

alternatively, you could try maybe some electrical tape? the stuff that is non-conductive. the worst thing you could do would be to put foil under them (i have seen a very **** mpc with this done before and it was awful).
User avatar
By JUKE 179r Mon Sep 17, 2018 5:02 pm
People still say “pause”? :hmmm:
By JaccCetch Mon Sep 17, 2018 6:05 pm
LOL Juke! I do...or course i'm old as well. Thanks for the reply Tape, your right, it somewhat does boil down to technique. I went ahead and installed MPCStuff's corx
again and spent some time focusing on technique and it really wasn't that bad.
By MrDismal Thu Sep 20, 2018 12:51 am
I recently installed the corx v2 - the rubber corx. At first they were double triggering in one corner, but now seems to be okay, I think they need a little wearing in. So much better without the air between the pads and sensor. 16 level basslines are actually doable again now.