MPC 2000 trouble

HI, i am having a problem loading old disks (of 2 or more) into my MPC 2000,
It is the same MPC i made the beats with but whenever i try loading them after the 2nd or 3rd disk it tells me NOT ENOUGH MEMORY, as i said its the same MPC i made these beats on and now i wont let me re-load them,i have taken the top of my machine to see if anything is loose but cant seem to see anything???please help

Open it up again, take out the RAM, clean the contacts with isopropyl and put it in again.

peace

umm which is the RAM? i have taken off both the top and 2nd layer of mpc, should i be getting to it from the top of the machine or the other way?thanks ;p

There are slots for two memory SIMMs at the very bottom of the PCB, close to the front of the case. You can't miss them.

Thanks,

i have taken out the RAM cleaned it and put it back in, still no improvement on the Memory Loss which has left me with about half the sample time that i used to have,
any others suggestions?

much appreciated for your reply,
;p

paulrepeat wrote:Thanks,

i have taken out the RAM cleaned it and put it back in, still no improvement on the Memory Loss which has left me with about half the sample time that i used to have,
any others suggestions?

much appreciated for your reply,
;p

you have two sticks of ram in there?

try them one at a time... turn on the mpc and check if it gives you the ram. it may be a faulty stick.

I only have 1 RAM in there should i get another and install?

Also i have copied an O.S. disk from another machine which works so i dont think there is anything on the old O.S. disk,

I also have many disks of 3 (or more) which still wont load after the 2 disk so dont think they are all corrupt,

any other suggestions appreciated,

thank repeat