Input balance

It seems the input balance on mine is a dB out. Is there anyway to calibrate it (in the os or physical trim pots)?

Hello everyone btw.

how did you figure that. Did you sample something then take sample to a DAW?
Or can you just hear one side is louder than other side. Swap cables first in and out.
Then check that if you are resampling and have balance out first. Is it just sampling or monitoring the through put as well.

It's from a "mono" signal from a DAW. Going into the stereo (I know I could mono it) but the let side is registering as a block (on the vu) louder than the right. Not sure what the block represents in terms of dB.

I can hear it and it's defo not the cable...

Have you tried other sound sources to confirm the imbalance is persistent?

Yes I have

Just did a quick sinewave sweep. It seems to happen at certain frequencies, and on sharp attacks. rms wise it's bang on.

Odd, anyway thanks for getting back to me.