Post your questions, opinions and reviews of the MPC1000. This forum is for discussion of the OFFICIAL Akai OS (2.1). If you wish to discuss the JJ OS, please use the dedicated JJ OS forum
It seems the input balance on mine is a dB out. Is there anyway to calibrate it (in the os or physical trim pots)?
Hello everyone btw.
Posts: 12
Joined: Sat Nov 10th, 2012
how did you figure that. Did you sample something then take sample to a DAW?
Or can you just hear one side is louder than other side. Swap cables first in and out.
Then check that if you are resampling and have balance out first. Is it just sampling or monitoring the through put as well.
Advanced Member
Posts: 2249
Joined: Tue Oct 5th, 2010
Location: Brisbane Australia
It's from a "mono" signal from a DAW. Going into the stereo (I know I could mono it) but the let side is registering as a block (on the vu) louder than the right. Not sure what the block represents in terms of dB.
I can hear it and it's defo not the cable...
Posts: 12
Joined: Sat Nov 10th, 2012
By
m56p87
Sat Nov 10, 2012 4:59 pm
Have you tried other sound sources to confirm the imbalance is persistent?
Valued Member
Posts: 1180
Joined: Fri Jul 13th, 2012
Location: seattle
Yes I have
Posts: 12
Joined: Sat Nov 10th, 2012
Just did a quick sinewave sweep. It seems to happen at certain frequencies, and on sharp attacks. rms wise it's bang on.
Odd, anyway thanks for getting back to me.
Posts: 12
Joined: Sat Nov 10th, 2012
