By Jamon
Thu Sep 24, 2009 10:09 pm
Learning how to build instrument programs on JJ OS2XL. Only had it for a few days so still newbie.
This is a single sample, single layer, recorded acoustically without effects using a microphone.
Then I trimmed it, started a new instrument program, and selected the sample for all notes.
Used the parameters to try and give it life, like a full instrument instead of typical pitchy sound.
Tapped out some notes using the pads into a short sequence, no FX, no EQ, no pitch bends.
This is the dry instrument program as the MPC plays it, no tricks, single short sample.
http://jamon.name/JJ+OS+instrument.wav
With multiple layered samples and FX I could get a fuller sound, but it used almost all 32 voices.
This doesn't use many voices, it says 3 for a single note, and practically no RAM.
There was no automation, just single notes, but adding Q-link filter changes could add expression.
This is a single sample, single layer, recorded acoustically without effects using a microphone.
Then I trimmed it, started a new instrument program, and selected the sample for all notes.
Used the parameters to try and give it life, like a full instrument instead of typical pitchy sound.
Tapped out some notes using the pads into a short sequence, no FX, no EQ, no pitch bends.
This is the dry instrument program as the MPC plays it, no tricks, single short sample.
http://jamon.name/JJ+OS+instrument.wav
With multiple layered samples and FX I could get a fuller sound, but it used almost all 32 voices.
This doesn't use many voices, it says 3 for a single note, and practically no RAM.
There was no automation, just single notes, but adding Q-link filter changes could add expression.




