
By nuts
Sun Sep 19, 2010 12:08 pm
Hi, i have it hooked up to my MPC300 (Vailixi 3.50) and want the upper slot to be enabled.
Actually i want it to be able to be seen by mpc 3000, or connected at the same time to my 3000 and my Roland S760.
Looks possible as it is stated on scsiforsamlers website but how please ? Mine is a RD300 with a rear scsi id switch and hd50 connectors.
I finded some documentations on MPL website but it didn't really help until there.
No .pdf about my specific version, but MC disk-G seems the closer.
See at the bottom of the page: http://www.mpl.ch/t6000.html
What settings must i change inside ? A jumper or something ?
Thanks a lot
Samuel
Actually i want it to be able to be seen by mpc 3000, or connected at the same time to my 3000 and my Roland S760.
Looks possible as it is stated on scsiforsamlers website but how please ? Mine is a RD300 with a rear scsi id switch and hd50 connectors.
I finded some documentations on MPL website but it didn't really help until there.
No .pdf about my specific version, but MC disk-G seems the closer.
See at the bottom of the page: http://www.mpl.ch/t6000.html
What settings must i change inside ? A jumper or something ?
Thanks a lot
Samuel

