Share your knowledge on these two classic MPCs
User avatar
By nuts Sun Sep 19, 2010 12:08 pm
Hi, i have it hooked up to my MPC300 (Vailixi 3.50) and want the upper slot to be enabled.
Actually i want it to be able to be seen by mpc 3000, or connected at the same time to my 3000 and my Roland S760.

Looks possible as it is stated on scsiforsamlers website but how please ? Mine is a RD300 with a rear scsi id switch and hd50 connectors.

I finded some documentations on MPL website but it didn't really help until there.
No .pdf about my specific version, but MC disk-G seems the closer.

See at the bottom of the page: http://www.mpl.ch/t6000.html


What settings must i change inside ? A jumper or something ?

Thanks a lot

Samuel
User avatar
By nuts Mon Sep 20, 2010 5:07 pm
It is up and running fine with my MPC3000, i can copy a card from a slot to the other or whatever...just nice.

Still wait a cable to try both 3000 and S760 at the same time.

Thanks again
By scsiforsamplers.com Tue Sep 21, 2010 4:18 pm
No selling on information! I give that document away to anyone who asks. It doesn't really lend itself to being posted here because it covers opening the drive and has many pictures.

The basic information you need to enable dual-slot mode is that there is a bank of 8 sets of jumper pins on the front right side of the drive and you add a jumper plug to the 6th set of pins (counting back from the front of the drive). Very easy.
By Arks Thu Sep 23, 2010 12:37 am
nuts wrote:Fortunately, not everybody is as venal as in your game. If so those forums will have no meaning.
Do you really want to sell a jumper setting? Come on.


just a joke mate :D

not sure if you've heard of this genre called "hip hop", but there is a "rapper" called 'Snoop Dogg', and ... oh, nevermind :wink: