chickensys translator s1000 to .akp to 5k doesn't work

from s1000 to .akp, it gets the pitches right,but sustains the notes endlessly when you try to play them ( i tried adjusting the release
in program mode,but it doesnt change it. in trim, the samples all play fine-
any thoughts ??
d

ps- i guess i should clarify that translator converts to akp ok for playback on an akp native sampler, but
the screwups happen when the 5k tries to play those converted progs

Hmmmmm! Try this...

In EDIT PROGRAM on MPC5k (Mode > PROGRAM), move the cursor to the sample name and press WINDOW. What does it say for playback? I am suspecting it's showing ONE SHOT. If so, set KGP: to MUL (multiple pads), move cursor to the appropriate layer and select NOTE ON.

That should sort it.

If it's not that, I have no idea what the problem could be.

However, I am suspecting Translator is flagging the S5000's PLAYBACK parameter in the program in such a way that the MPC5k doesn't like it. But I could be wrong.

hollowsun wrote:Hmmmmm! Try this...

In EDIT PROGRAM on MPC5k (Mode > PROGRAM), move the cursor to the sample name and press WINDOW. What does it say for playback? I am suspecting it's showing ONE SHOT. If so, set KGP: to MUL (multiple pads), move cursor to the appropriate layer and select NOTE ON.

That should sort it.

If it's not that, I have no idea what the problem could be.

However, I am suspecting Translator is flagging the S5000's PLAYBACK parameter in the program in such a way that the MPC5k doesn't like it. But I could be wrong.

heya Steve

they are all on NOTE ON-

I dunno whats up
d

Try setting it from NOTE ON to ONE-SHOT and then back again to NOTE ON.

Could a small display problem.

Or it may not