Problem with the pads' volume

My problem is,that pads 1-3 are loud as ****.but the others are too quiet. How can i play all the pads on the same level?

depends i guess.

which mpc do you have?

The 500

oh idk.

then i guess read the manual.



why not try it right now. look around??? nothing will happen to your mpc if you look for it. its not like your going to move a setting and blow a circuit. hahah.

I guess,it is easier to ask a question from the pros in a sentence,than searching for it in the manual for couple of hours.

If you dont know the answer,you dont need to post,and say,that i should read the manual...

What is "getting started" good for,if you alwasy say "read the manual" instead of offering some help...

Thanks for at least trying to help tho

Remember that pads are set to (I believe) 70% of their maximum volume - have a look in the PROGRAM mode (i.e. hit mode and pad 6 and go through the options). Make sure you're looking at the correct pad when you go through the options - especially if you think Pads 1-3 are as you'd like.
I don't have my mpc with me (am at work right now) but this would be a good place to start.

M

markmorgan10 wrote:Remember that pads are set to (I believe) 70% of their maximum volume - have a look in the PROGRAM mode (i.e. hit mode and pad 6 and go through the options). Make sure you're looking at the correct pad when you go through the options - especially if you think Pads 1-3 are as you'd like.
I don't have my mpc with me (am at work right now) but this would be a good place to start.

M

Thanks,ill try it!

It actually works,but when i turn it off,and then turn it on again,it forgets the settings,and again plays some of the pads at 70% volume! Could you pls tell me how to save those settings?