Rotary Encoder (Jog Wheel)

Hi,

Do any of you guys know where to get/find the technical specifications for the "Alps Rotary Encoder" ES-812342J?

http://1226354.estore.networksolutionsd ... bok?no=206

Also, do anyone know of any resellers in europe thats selling this one?

Cheers.

/Mike

I dont know about the specification of the original MPC encoder but maybe the people at conrad can help you.

ENCODER STEC12E07
http://www1.conrad.de/fas6/fh.php?fh_ho ... w%3Dsearch

peace

Alrigth, thanks Have you used this one on a MPC? I sure looks like the original alps encoder.

Cheers.

/Mike

No I didnt test it. I just found it before I posted it.

peace

Alrigth... i was able to get a few "Alps STEC12E07 Rotary Encoders" directly from Alps for evaluation. I solderd it on today and it works perfect.

Peterpiper: Thanks for the advise on the STEC12E07 Rotary Encoders!

Cheers


/Mike

Nice that you share your experience. Thank you.

peace

i was at conrad and bought 2 of them u mentioned above. mine isnt damaged so far, but to have 2 of them in storage should be a good idea

but i got a question:
do you have to cut or "shape" the shaft where the data wheel sits or does it fit perfectly to the wheel? (if you understand what i mean)

just for information, so i dont have to ask in the future and to complete this thread.

WASKMUSIC wrote:i was at conrad and bought 2 of them u mentioned above. mine isnt damaged so far, but to have 2 of them in storage should be a good idea

Your screen will probably fail before you use up the current one plus the two extras.

Check this old thread:

viewtopic.php?f=1&t=127446

haha thanks for the info.

my screen is just like new, bright, no lines or dead pixels. sometimes if i turn my jogwheel to the left it first skips 3 values to the right and then it goes left. so, its not a big problem yet, but i bought them today for having some in stock if my rotary encoder dies out