4 block jumper termination settings for MPC 3000

Hello MPC heads!

First of thanks for your help in advance! This board has been of great help to me over the years! Anyways after finally getting a card reader for my MPC 3000 I am having problems with it being recognized as a SCSI device. It is internally installed and I have the internal kit (Thanks for the internal kits JD @ SCSI 4 Samplers ;D !!!) I just had the SCSI board serviced & replaced the fuse. I have used the Search function on the site for block jumper settings lots about other drives however I could find nothing helpful.

Does anyone know what the correct Block Jumper settings which sets termination for a MC Disk 2 in a MPC 3000?

Again many thanks!

I am PM'ing you now.

**Update finally up & running 100%! Thanks to JD @ scsi for samplers (for the internal kits &) for all his knowledge!

I am awaiting the arrival of my internal drive. May I ask what was the issue so I can possibly avoid it?

I sent your drive with the jumpers already set how they need to be. You'll be all set to install it when it arrives in a few days.

scsiforsamplers.com wrote:I sent your drive with the jumpers already set how they need to be. You'll be all set to install it when it arrives in a few days.

great-thanks JD

deegood wrote:I am awaiting the arrival of my internal drive. May I ask what was the issue so I can possibly avoid it?

got my internal drive back today. installation was fairly easy. everythings working great! THANKZ to JD (scsiforsamplers). CHEERS!!!!!

Dee, glad to hear everything installed easy. We aims to please. Thanks for your bizness.