ASSIGNING FX TO Q-LINK

* Improvement of limiting FX parameters on Qlink pages when changing FX Type after Qlink has been assigned to FX parameter.

can anyone tell me how this is done
thanks

AWW_NAWW wrote:* Improvement of limiting FX parameters on Qlink pages when changing FX Type after Qlink has been assigned to FX parameter.

can anyone tell me how this is done
thanks

I'm not sure the question is very clear. Are you talking about the range
of control. If so, you can assign the q-link to an fx send and then to limit it, just change the range field that it will effect. this can be done with any contol.... for example filter sweep, range -100 to +100. you can choose for example range +50 to +100 so that when the q-link fader is all the way
down , the sound is not completely filtered even if the cut-off is all the way down.

hope this helps

AWW_NAWW wrote:* Improvement of limiting FX parameters on Qlink pages when changing FX Type after Qlink has been assigned to FX parameter.

can anyone tell me how this is done
thanks

Go to Qlink and change part to FX at the wet/dry field you can change to any parameter in the effect you want too. For example you can assign digital eq to FX 1 and set each qlink to a different part of the the eq range frequency, gain, and q. I hope that helps.

HAZE, YOU HIT IT RGHT ON THE NOSE. THANKS
AND THANK YOU TOO DEAF