assign 2 samples to 1 pad (1 w/ efx)

hi everyone!

is there a way to assign 2 samples to a pad BUT 1 with efx, the other one just plain..?

it's about adding a filtered dublicate of the sample to the same sample and activate both of them with one pad at the same time.
1 pad just normal without any efx, the other one is just the low frequency of the first sample.
it's for adding not a whole bassline, but more bass to a sample.

i hope you know what i mean.

if you do know what i mean, and also know that there is no way to do as i wish or it would cause no effect at all, is there any other way to increase the low freq. of a sample (on a pad)?


help is highly appreciated!

peace ya'll

edit:
and how i'm i supposed to get a song i've created to the computer?
when i press [status] it says 16%wav 96%sq. whatever that means....
and the rest record time is 8 seconds so i can't record my song as sample an then flip it to the pc.

what else can i do?

You know, you're going to have to resample those samples and lay them down as is. At least thats how I do it.

okay, i see.

and is there any other way to record get it on my computer?

for you, who has obviously not even bothered to even glance at the manual - the answer is no. your songs will be stuck on your MPC forever.

ok. no problem. i'll take a new mpc for every beat and never shut them down.

no srsly: name the page and i'll check it out.
on the german manual its page 90ff and it says exactly that i have to record the sang as a sample.

If you don't want to put your own time into your problems, then why should i even care using my time on you? I even told you where to find the answer silly fool.

Remember that old Ragu commercial?

''Its in there''

RTMFM.

And chill with eimer, he's the man around these parts.

Eimer LOL!

FreshLab: p.64 of manual (ENG) explains how to resample MPC's output. But if I were you, I'd just connect MPC's stereo-outs to the soundcard input(s) and record directly into a DAW or audio editing software. You will need 1 or 2 audio cables, depending on you setup. I'd also suggest that you not simply just record the song on your PC hard-drive, but also record different parts as a multitrack. For example: kick drum track, snare drum track, hats, bass line, etc. This will give you more flexibility in mixing and adding virtual instruments using your DAW.

eimer wrote:If you don't want to put your own time into your problems, then why should i even care using my time on you? I even told you where to find the answer silly fool.

and i even posted up the page i found, so what more do you want?
you could name just the chapter i can find more infos in but i guess thats too much.


but its all good, i found a way on my own.


edit:
thx brazeca, i really appreciate it!