Loop edit mode is stuck on bar 1

I'm in a hurry so i'll just post a link to the manual: http://www7a.biglobe.ne.jp/~mpc1000/os2/grid_lem.htm

jj says: "1 bar edit mode window of the bar on vertical cursor will open."

I assume that means the bar the cursor is on will be the one that is active when i press the window key? That's not happening; loop edit stays on bar 1 and i can't change it. I tried setting the loop range but it remains on bar one. Any way i've gotta scoot so i'll check back later. Cheers.

Don't worry about the loop range-- that's totally separate.

I'm not sure what's going wrong for you but try this-- When you have 1 Bar Edit open on the 1st bar, press the >bar transport button on your MP. Does it then show bar 2?

elevated wrote:Don't worry about the loop range-- that's totally separate.

I'm not sure what's going wrong for you but try this-- When you have 1 Bar Edit open on the 1st bar, press the >bar transport button on your MP. Does it then show bar 2?

Yeah that did it, thanks! I love os2!