technics rebuild tutorial

well burning plastic isn't that bad if you do it outside like I did

hey gren can you take a photo of the main pcb,,a close up..and i'll see if theres a way to wire a pitch control.

I'm pretty sure it's possible because of the 33 and 45 screw things that alter the speed, I just don't know how

thanks,,let me see what i can do,,but not much to work with there..what deck is that?

onkyo cp-1100A

Tis is the dopest shit I ever seen. Imma buy a MPC 1k tomorrow, you think the same trick for ball-less faders would work on a MPC?

gren,,if i had access to your deck and a fader i think i could get it to work...you would have to wire it in between the vr1 and vr2 but without testing it,,i cant tell you wich is wich..can u test them tabs with a multi meter?

edit..the four undernieth.

WoW! thanks for the rebuild tutorial....

hey, I noticed your audio cable PCB was mounted inside of your tonearm. Mine isn't, do I go a different way about grounding it? if I was to internally ground that is.

actually forget it, I'm not going to do it if a pitch control cost more than $5 cause thats all I'm willing to spend on that thing. but thanks anyway

wow, thank you for sharing your knowledge. i would love to be able to do this, and to customise mpc's etc.

i've just started studying electronic engineering at university, so hopefully will get somewhere near the skill level your at -in a few years time.

thanks again for this brilliant tutorial Sonseelye

yo thanks for postin this man. i dissassembled a technics1200 today that had the RCA wires improperly replaced. previous owner was a cheap ass used a hosa cable.

my main goal was to fix the rca cable but while this thing is open i feel like i should do the ground wire. but i have a question about your ground wire mod. i didnt really understand where you soldered the short wire too. alot of people online say to solder it to the right ground of the rca. is there a reason you dindt do it this way? or am i missing something.

yep you missed something

sonseelye wrote:now take the small 1 inch wire and the ground from the red side of the rca and solder both of them to the rca tab like so

thank you for the clarification. i see where the short wire is soldered to the red rca ground wire tab now.