My MPC1000 goes crazy

Hello people,
I have a MPC1000 with JJos1 4.99 and os2 1.29 that goes crazy after a few minutes of turning it on.
It puches random buttons, but I'm not doing anything.
It does this on both os.
I've tried searching but could not find anything.
Can you help me?
Best Karl.

Try to reinstall it with another cf card.
If that doesn't work u'r probably ****

stop doin the OUIJA board !!!!!!!!!!!!!!!

you have prolly got the j dilla ghost lurkin round ya house

BE VERY CAREFULL

SPOOKY SPOOKY

did you see the film "THE ENTITY"

dont be surprised when

J DILLA .............................TRYS TO MOLEST U WEN U SLEEP

HAVE A NICE DAY

I had the same problem with my MPC 1000....could be that you have a bad connection inside your MPC.

What you can do is open up your MPC on both sides and disconnect/connect all connectors visible....at least this helped with my MPC.

If this doesn't help it could mean that you have a old set of pads which has gone bad....only way to solve this is by the new pad set at MPCstuff.

RodmanSan wrote:I had the same problem with my MPC 1000....could be that you have a bad connection inside your MPC.

What you can do is open up your MPC on both sides and disconnect/connect all connectors visible....at least this helped with my MPC.

If this doesn't help it could mean that you have a old set of pads which has gone bad....only way to solve this is by the new pad set at MPCstuff.

Thats what I thought.
I will disconnect/connect the connectort and hope that that works.
Thanks for helping.

P.s. I have the new pads.

What you could also do is clean the connectors with some alcohol so you are sure that no residue or anything is left on it which prevents a good contact.