MPC 2000xl SCSI conflict problem

I'm trying to ues a zip 250mb drive and when I try loading the drive It shows a SCSI conflict on SCSI ID#6, Any help forthis problem

Just set the zip drive to scsi #5
It's a switch on the back of the drive






viewtopic.php?f=1&t=70545

still getting the conflict on ID#6

Does the back of your zip drive look like the one in the picture? And if it does, are both switches down? Push both switches up and down a few times - I have seen a zip drive get kind of stuck, where you think a switch is one way but it really isn't.

But first ...

Did you power off the zip drive before you changed the switch settings? That is required - the proper order is: power off the MPC, power off the zip drive, modify the switch settings, power on the zip drive, then power on the MPC. That should solve your problem.

Remember that you always power on your SCSI drives BEFORE you power on your sampler. Then when you are done working, power off your MPC first, then power off your SCSI drives.

It was stuck just like you said, thanks alot. You got skillz!!!!