MPC1000 Program Creator

Downloaded the MPC1000 Program Creator - could be a great tool! (http://www.mpc1000.com/create/index.htm).
Great initiative!
But when I test the samples by hitting the virtual pads, the samples are an octave to high even though the tuning is set to 0. Using the autoplay (doesnt always work) plays the samples in correct tuning while clicking in the file - but not after moving them to the pads. It makes is pretty impossible to test out the program before exporting to the MPC. The samples I use is standard (mono/stereo, 44100, 16).
Any suggestions?

What O.S. are you using on your pc? I have XP SP2 and haven't had any problems with it.

same ish happens to me and i run XP Pro...i tried a number of things but eventually gave up

There is now a new release posted that should fix this issue.

Imagine if AKAI was this effective! Thank you VERY much!!!
I have put two samples in:
http://omvendt.dk/temp/
The first doesnt play in autoplay, but the second does? They are both mono and 44100/16.
I wish I was able to make programs like that!
You have my greatest respect!

The autoplay has problems so the backend for it is getting reworked.

So I will have to wait for more than a couple of hours this time?

you lost me homie...does the new jawn work or not?

chupacabra wrote:you lost me homie...does the new jawn work or not?

The "samples are an octave to high"-issue is fixed. But the autoplay-issue is not yet fixed.

mpc pad 187 is mac only correct?

chupacabra wrote:mpc pad 187 is mac only correct?

Yep:
http://ieee.usask.ca/members/snorum/mpcpad187/help/