Trim speed on Mpc 1000 too FINE

i have an mpc 1000 and im having trouble with trimming samples..

whenever i try to trim a sample by spinning the data wheel it takes ages to move across the sample. it takes hundreds of rotations to get to the part i want to get to..

the length of the sample is only 2 seconds long sometimes like a kick and snare.

I was wondering if you could help me speep up the sensitivity with my data wheel in trim mode.

its too fine

thanks

SEE ANSWER IN THE OTHER THREAD U STARTED

dcook79 wrote:SEE ANSWER IN THE OTHER THREAD U STARTED

Or get JJOS!

If you hold down the "AFTER" key above the Q-Link sliders, it adjusts the start (top slider) and the end (bottom slider) points for both trim and loop modes.

Hell yeah. First post, too!

dude, I just got my 1000 YESTERDAY, with no manual, and I figured this out. Hold shift and left or right to increase the position faster.

Destinite wrote:dude, I just got my 1000 YESTERDAY, with no manual, and I figured this out. Hold shift and left or right to increase the position faster.

nice....

i got jjos 4.99

no need for that now