By madelot
Wed Jul 14, 2010 5:25 pm
Hi,
I got my MPC 60, it is a 120V one. I connected it to 220V without a transformer, so the fuse F1 with 1,25A smoked. I replaced it and got myself a step-down transformer. It worked for a few hours but then it went off and wouldn't go back to life. I opened it again and found Fuses 2, 3 and 4 blown. I replaced those, too. Now only F2 (3,15A) was blown again. I think it is wired to the transformer block. I've seen posts of people commiting the same sin, but their MPCs started working after replacing F1. Any tips as to how to proceed?
It's my first post - sorry it has to be such a desperate one.
Thanks
I got my MPC 60, it is a 120V one. I connected it to 220V without a transformer, so the fuse F1 with 1,25A smoked. I replaced it and got myself a step-down transformer. It worked for a few hours but then it went off and wouldn't go back to life. I opened it again and found Fuses 2, 3 and 4 blown. I replaced those, too. Now only F2 (3,15A) was blown again. I think it is wired to the transformer block. I've seen posts of people commiting the same sin, but their MPCs started working after replacing F1. Any tips as to how to proceed?
It's my first post - sorry it has to be such a desperate one.
Thanks