
By The Grublet
Fri Aug 06, 2010 9:17 pm
!!!!!!!!!!!!!!!!!!!
LMAO
you assholes could have told me there was a "termination" switch on the back panel.
WOOHOOO.
OK im stuck.
I am trying to put a 36 GB Hard drive in my s6000...
I wired it in, even added a separate power switch so it does not spin constantly...
I cant get it to read.
It says: fatal exception on scsi ID 0, which is the drive.
Is this a SCSI Device conflict?
should I change the device ID to 5 or something?
I know once I get it formatted, it will read just fine, but even when I boot with the HD not plugged into the scsi cable, then plug it in while it is on, and go to disk screen to format, it does the same fatal exception screen. any Ideas?
Thanks in advance.
LMAO
you assholes could have told me there was a "termination" switch on the back panel.
WOOHOOO.
poundaproblem wrote:"...dudes like me. Dudes who started YEARS ago and spent HOURS, DAYS, WEEKS, MONTHS, YEARS to learn our craft just so some little swaggot can buy an MPC, download a DAW and call himself a producer."





