Newb question: Adjusting start/end points of regions with Q

How is it possible to adjust the start and end points of the regions in a sliced sample using the Q link sliders?

Am I limited to using the cursor/data wheel?? i've used a 2Kxl and holding shift + moving slider you can adjust this.



I'm using the current software as downloaded today (september 6th, 2010)

I know this is possible with JJOS.

Don't know about on the 1000, but on the 4000 you press ACTIVE below the Q-link slider and then move it while holding the button.

One Q-link is for the start point and the other is for the end point.

clint246clint wrote:Don't know about on the 1000, but on the 4000 you press ACTIVE below the Q-link slider and then move it while holding the button.

One Q-link is for the start point and the other is for the end point.

Damn Clint, I NEVER knew that! (Internet High Five)

Have 1 free internets... On me!

actually, I believe this feature was removed from the later JJOS's I think it only works on akai os

TribeCalledQuest wrote:actually, I believe this feature was removed from the later JJOS's I think it only works on akai os

I'm using the AKAI OS, latest v2.13. The only other answer i could find is to hold down the AFTER button while using the slider but this does not work..

But even using the DATA wheel is PAINFULLY slow and only tracks in incredibly small increments. Is there a way to increase this? and is there a way to zoom in while adjusting Region/slice start end points??

Nobody here has a solution?? u gotta be kidding me

Have you tried holding down "Shift" + left/right cursor key to move the indicator.... It's in the manual.

well, i did label newb in the thread title

but can you not do the same with the Q slider? I was used to this on the 2000xl. Or is this only available in JJOS?