By masterh
Fri Sep 17, 2010 2:50 pm
HI!
I downloaded the new OS version 1.24 yesterday.
After installing it on my MPC, i realized that somthing is wrong with the sync out master midicloc.
I have most of the time used my mpc as a mother midi sync unit with four other synths an stepsequensers like korg electribe.
And this have been perfectly operating(3 years) - until this OS update:(
Description:
The external seceuenser follows when startbuttom is pressed- so the start-stop message seems to work.
BUT right after that - in the first count of first BAR the clock lags so the ext.sequensers slip to aprox. 1/8note behind the MPC-- And stays there
Any ideas?
I downloaded the new OS version 1.24 yesterday.
After installing it on my MPC, i realized that somthing is wrong with the sync out master midicloc.
I have most of the time used my mpc as a mother midi sync unit with four other synths an stepsequensers like korg electribe.
And this have been perfectly operating(3 years) - until this OS update:(
Description:
The external seceuenser follows when startbuttom is pressed- so the start-stop message seems to work.
BUT right after that - in the first count of first BAR the clock lags so the ext.sequensers slip to aprox. 1/8note behind the MPC-- And stays there
Any ideas?