HELP.. BiG Pad problem on mpc3000

I suggest replacing the sensor sheet. It has to be damaged.

mr_debauch wrote:I suggest replacing the sensor sheet. It has to be damaged.

hmm, is there any way to test the sensors sheet
first, or the board it's connected to before going
further ?

maybe I should buy a digital multimeter to
test contacts properly?
was looking for the MPC3000 electronic shematics
to clearly see what connects to what?
it's not in the MPC3000 service manual....

jazzroom wrote:

mr_debauch wrote:I suggest replacing the sensor sheet. It has to be damaged.

hmm, is there any way to test the sensors sheet
first, or the board it's connected to before going
further ?

maybe I should buy a digital multimeter to
test contacts properly?
was looking for the MPC3000 electronic shematics
to clearly see what connects to what?
it's not in the MPC3000 service manual....

yeah there is a real good way to test the sensor sheet... you did that already and found 5 pads not working. I mean... maybe you should be careful though cause you dont want to dig your hole any deeper.