By Larrygates
Wed Oct 20, 2010 6:29 pm
Another little SNAFU when using the 4000. On the 3000 I use MTC to slave the DAW to the MPC (No Midi Beat Clock or the DAW being the Master since the MPC has superior timing etc . . .)
Anyway, on the 3000 I would change sequences to follow the song structure. No problem as the DAW would keep playing down the timeline. Well with the 4000 whenever I change Sequences the DAW will start back at bar 1. Doesn't happen on the 3000 just found this out about the 4000.
Anyone know of a way to tell MTC or the Sequences not to restart time code with each seq change, or is song mode my only hope? Which I NEVER use song mode. Hate that mode.
Anyway, on the 3000 I would change sequences to follow the song structure. No problem as the DAW would keep playing down the timeline. Well with the 4000 whenever I change Sequences the DAW will start back at bar 1. Doesn't happen on the 3000 just found this out about the 4000.
Anyone know of a way to tell MTC or the Sequences not to restart time code with each seq change, or is song mode my only hope? Which I NEVER use song mode. Hate that mode.