What holds your floppy ?

Hey Ya'll,
Hope yous are all well.I havent been here for a while as I botched a repair and couldnt bare to come here and read about MPC's while not being able to use it.

My MPC60 came with no floppy drive installed. What is supposed to hold it in place inside the MPC ? Is it a caddy or is it screwed straight onto the case or what ?

I had a look at the service manual and Page 23 shows that the floppy drive sits on what looks like 2 little blocks/bars.
Anyone know what height these need to be so the floppy drive sits level with the hole in the casing ?
Is it 4mm ?

They're taller than that - more like 1cm

Anyone know where u can get faceplates for these drives?

everytingire wrote:Anyone know where u can get faceplates for these drives?

Buy a dead drive and salvage the bezel. Warning: they're a right PITA to remove without bending the chassis I've found.