Sell broke PCB Boards???

I just replaced the right pCB board and the q slider boards. I dont know anything about soldering. Do yall think i can resell these on ebay for 10-20 bucks or should i just trash em?

What's wrong with the boards?

THE ENCODER ON the right board was bad so i replaced the whole thing since no one on earth sells replacement rotary encoders. and one button, the right arrow button needs to be pressed hard. Bad tact. the qlink sliders were acting up. they would jump around and would not stay on one value.

You could have used deoxit to fix all them problems.

naw Deoxit didnt work.

damn seriously?