To all my broken tact switch heads... Will these work?

Nah those have a ground terminal, which i think, and someone correct me if I'm wrong, is a fifth contact pin. I would get something that matches the specs to the ones I ended up installing (the spec on the operating force is a matter of preference).

Look at

viewtopic.php?f=21&t=140732

The tact switches there are highly recommended. My MPC feels sleek now, it has so improved my attitude towards my MPC from - turning it on only if I had to - to - turning it on just to see how smoothly it works now. These tacts make it a joy to use & are designed to 1million operations, so won't be replacing them for a while.

Thanks for the feedback guys I found those ^^ switches on mouser I'll give those a try and let you know how it goes.



Biggs

Hey, Im trying to take apart ribbons so i can get under at the tact switch, but i cant get the ribbons off. whats the secret? espp the ribbon on the lower left that goes into the pads. how in the heck do you get that one off? i searched youtube and found no vids on taking it apart. Ima make one if yall help me do this. thanks

peace

A small flat head screwdriver (an electronics or eyeglasses screwdriver works well) can be used to carefully pry the connector apart. Just work it between the two pieces until it loosens up then disconnect.